Precautions for operation steps of metal hose filling and sealing machine:

1. Clean the sundries in the hopper, add materials, and place the hopper filler cover in place;

2. Turn on the power supply of the metal hose filling and sealing machine, press the main power switch, and the counter displays 0; When the main power switch is pressed, the frequency converter displays "off". When the material reaches the required temperature, press the "run" button on the frequency converter, and the frequency converter displays "LS". At this time, turn the frequency converter knob clockwise (do not damage the inner tooth surface of the knob with too much force and slip), the motor will start, the indexing plate will run, and the tail sealing mechanism will start to run (the frequency converter knob can be adjusted to the appropriate running speed at any time during operation);

3. Press the filling button of the metal hose filling and sealing machine (the photoelectric probe starts working) to start intubation (the machine inserts the tube manually). When the rotary table drives the empty tube to the filling nozzle, the photoelectric probe will receive the signal and start filling (filling the tube seat without tube). When the metering pump completes an action, the microswitch receives the signal and the filling stops. The metering pump runs once and the counter counts once (the counter can be reset and counted again at any time); This cycle. (the new filling machine discharges the air in the metering pump, so it is empty filling);

4. Check the filling volume and adjust the measured value if there is any difference.

5. After the metal hose filling and sealing machine is completed, turn off the filling switch in turn, turn the inverter knob counterclockwise until the indexing plate stops running, and cut off the power supply.

During the operation of the metal hose filling and tail sealing machine, do not touch the operating parts by hand to avoid accidents. After adjusting the measured values, be sure to lock the nut. If there is any abnormal response during the metal hose filling and tail sealing machine operation, the machine will not start until the cause is found. When filling large capacity containers, the diameter of the filling nozzle should not be too small to prevent accidents Rubber sprays or nozzles are damaged due to excessive pressure during filling.